0.1, 0.25 and 0.5 mA/cm2 current densities were used as variable condition in Iontophoresis while keeping selleck inhibitor current pattern as continuous DC current. DTAB micellar solution containing Lovastatin in phosphate buffer pH 7.4 was charged in donor compartment of modified Glickfeld diffusion cell. In one experiment, 0.5 mA/cm2 DC current source was kept in continuous mode and in the other

experiment it was kept in 10 s on/off (pulsed) mode. Ten to twelve week old male albino rats (250 g) were sacrificed by excess of ether inhalation. After removing hairs, full-thickness of rat abdomen skin was surgically removed. The rat epidermis was isolated by a heat separation technique and carefully cleaned with normal saline. Finally fat tissue adhered to skin removed by wiping it with cotton swab soaked in isopropyl alcohol and dried under the vacuum followed by storing in desiccators.7, 8 and 9 Skin samples were used within three days of isolation.

Protocols for the use of animal for the above experiment was previously approved from the Institutional animal ethics committee, Noble Group of Institutions, Junagadh. Iontophoresis experiments were carried out at 37 ± 2 °C. All analytical works for quantification this website of Lovastatin were done by validated RP-HPLC analytical method by using 0.1% phosphoric acid solution and acetonitrile (65:35 v/v) as mobile phase. Selected composition was charged for stability

study under accelerated stability study condition as per ICH guideline. Selected composition was studied for Zeta potential determination, pH and assay of Lovastatin and in-vitro permeation rate. DTAB was selected as a surfactant for composition for Iontophoresis experiments because single surfactant micelle possesses best solubilizing power than mixers of surfactants specially in context of micellar solubilization of drugs.10 Solubility of Lovastatin was found to be 0.1 mg in 3.7 × 10−3 mol/L of DTAB which is more than 230 folds generally observed in purified water. Fig. 1 show CMC of DTAB in 0.1 mg Lovastatin containing solution under various temperature conditions and it was evidenced that the maximum shift of CMC was up to 3.87 × 10−3 mol/L at Rebamipide 40 °C. So, use of 3.87 × 10−3 mol/L DTAB in composition can keep Lovastatin in soluble form in core of liquid crystals formed by micelles of DTAB. Passive diffusion of Lovastatin allowed 3.63 ± 0.10 μg/cm2/h Lovastatin permeation rate after 12 h Iontophoresis with 44.36 ± 4.02 μg/cm2 cumulative permeation of drug. Phosphate buffer pH 7.4 as vehicle system provided highest drug permeation with Permeation Enhancement Ratio (E.R.) 1.80 in comparison of passive diffusion (Table 2) (Fig. 2). Lesser E.R. was observed in case of NaCl containing solution may be due to counter ion effect produced by Cl− of NaCl on DTAB micelles.