“Autologous microvascular breast reconstruction is an incr


“Autologous microvascular breast reconstruction is an increasingly common procedure. While arterial

anastomoses are traditionally being hand-sewn, venous anastomoses are often completed with a coupler device. The largest coupler size possible should be used, as determined by the smaller of either the donor or recipient vein. While its efficacy Ibrutinib has been shown using 3.0-mm size and greater couplers, little is known about the consequences of using coupler sizes less than or equal to 2.5 mm. Methods: A retrospective chart review of patients undergoing autologous breast reconstruction was conducted at NYU Medical Center between November 2007 and November 2011. Flaps were divided into cohorts based on coupler size used: 2.0 mm, 2.5 mm, and 3.0 mm. Outcomes included selleck inhibitor incidence of arterial or venous insufficiency, hematoma, fat necrosis, partial flap loss, full flap loss, and need for future fat grafting. Results: One-hundred ninety-seven patients underwent 392 flaps during the study period. Patients were similar in age, type of flap, smoking status, and radiation history. Coupler size less than or equal to 2.0 mm was found to be a significant risk factor for venous insufficiency (P = 0.038), as well as for development of fat necrosis (P = 0.041) and future need for fat grafting (P = 0.050). In multivariate analysis, body mass index was found

to be an independent risk factor for skin flap necrosis (P = 0.010) and full flap loss (P = 0.035). Conclusions: FER Complications were significantly increased in patients where couplers of 2.0 mm or less were used, therefore to be avoided whenever possible. When needed, more aggressive vessel exposure through rib harvest, the use

of thoracodorsal vessels or hand-sewing the anastomosis should be considered in cases of internal mammary vein caliber of 2.0 mm or less. Therapeutic Level III. © 2013 Wiley Periodicals, Inc. Microsurgery 33:514–518, 2013. “
“Intraoperative near-infrared indocyanine-green (ICG) angiography enables the visualization of microvascular perfusion and may help in the early detection of complications. The purpose of the present study was to examine whether the effect of microvascular stenoses can be quantitatively assessed by analysis of ICG-angiography in a microvascular model. Graded stenoses and total vessel occlusion of the carotid, aorta, and femoral arteries were created in 25 Wistar rats. Stenoses were graded to reduce arterial flow by 25%, 50%, 75%, and 100% of baseline flow as measured by transit-time flowmeter analyzing the emission signal of the ICG detected and investigated by the mathematical software tool (FLOW 800). ICG angiography was performed to assess vessel perfusion and flow curves were analyzed and correlated with the stenosis rate. A total of 576 investigations were performed. The area under the curve (P < 0.001), first and second maximum (P < 0.001), and the maximum slope to the first maximum (P < 0.

Comments are closed.